Home Improvement Information

Removing Your Old Sliding Glass Door


Last week I explained how to measure your existing sliding glass door so you can order the vinyl replacement door. This week I am going to go over the steps required to remove the old sliding door before installing the new door.

First, you have to remove the sliding panel and the stationary panel. The vast majority of doors out there have the sliding panel on the inside half of the track, and the stationary panel is on the outside. Whatever the case in your particular door, the outside panel has to come out first. To remove the fixed panel, you need to remove the sill cap that snaps into the bottom track and runs from the fixed panel to the side jamb where the sliding panel locks. Force a screwdriver into the crease and pry the cap up. Then, look for screws on the inside side jamb holding the fixed panel in place. These screws prevent someone from prying up the sill cap and pulling out the fixed panel in order to gain entry into the home. In addition to the side jamb, be sure to check across the top header and bottom track for screws there as well. Once all the screws have been removed, you need to pull the fixed panel away from the side jamb. You can start by simply grabbing the side rail of the fixed panel and pulling as hard as you can. If you're lucky, the panel will pop free. Then you can lift the panel up as far as it will go into the top channel and swing the bottom away from the track, and remove the panel.

Now, I said "if you're lucky", because in most cases the panel will be stuck in the side jamb, the bottom track, or both. Usually, you're going to have to use a pry bar to loosen the fixed panel before it will slide out of the side jamb. Once the fixed panel is out, removal of the sliding panel is usually easier. Just lift up and swing the bottom away from the track, then remove the panel. Sometimes the bottom rollers will prevent the bottom from swinging out of the track. If that's the case, you will need to find the roller adjustment hole in the bottom corners of the sliding panel. Put a screwdriver into this hole and turn the screw counterclockwise to bring the roller as far up into the bottom of the sliding panel as possible. This should allow the slider to come out.

Now, you want to remove all the screws from the side jambs, top header, and bottom track. Then, take a pry bar and get it under the bottom track about in the center. Pry up until the track is separated from the floor. The next step will depend on whether your old frame is nailed to the house frame, or simply screwed in. If it's screwed in, then the frame should now be loose in the opening, since you removed all of the screws. You just need to remove whatever inside trim there might be around the door frame. This type of frame should come out. If your door is nailed to the house frame, you will have to do a bit more work. Use a hacksaw to cut the track in half, approximately in the center. Start with either half and raise the cut piece up towards the side jamb until the the track piece separates from the side jamb. Do the same thing to the other half.

So, now you have to remove the side jambs. You want to do this without damaging the exterior material that surrounds the door frame. Take a heavy chisel and pound it into the crack between the frame and exterior material, whether it's stucco, siding, etc. Start at the bottom 6 inches first. What you are trying to do is pull the nail fin away from the nails holding it in place. So, once the chisel is pounded through the metal frame, pry away from the side wall. The heavier and longer the chisel, the more leverage you will have. You will hear the frame "pop" free of the nail. There will be several nails holding each jamb in place, so you want to start at the bottom and work your way to the top corner. Once you get the bottom third loose, many times you can grab the jamb with both hands and pull the rest of the nails free as you go up. When you get to the top corner, work the jamb free. Do both jambs, then do the top. Sometimes the top has no nails, or just one in the center, so it will come down pretty easily. Be sure to wear safety glasses and a dust mask when doing this job, especially when removing the top header.

At this point you are ready to install the new door. The installation procedure is slightly different, depending on whether you're installing a retrofit style frame or a replacement frame. We will discuss both procedures next week.

John Rocco has been installing replacement windows since 1978. To learn more, visit How To Install Windows


MORE RESOURCES:

Medill Reports

Home improvement retail sinks on data
Forbes, NY - 21 hours ago
AP , 11.19.08, 03:13 PM EST Shares of home improvement chains dipped Wednesday after the federal government said construction of new homes and apartments ...
How home improvement chains fared in 3rd quarter The Associated Press
Home Depot Posts 31% Fall in Net Income, Cuts View Wall Street Journal
Tough economy takes toll on Home Depot Atlanta Journal Constitution
Stockhouse - CNNMoney.com
all 524 news articles


Sector roundup: Solar, home improvement
Forbes, NY - 19 hours ago
CHICAGO (AP) - Shares of home improvement chains dipped Wednesday after the federal government said construction of new homes and apartments slowed at a ...


Ahead of the Bell: Home improvement retailers
Forbes, NY - Nov 19, 2008
The home improvement retailers are part of a sector that has "competitive dynamics, stable gross margins through the downturn, and clear cyclicality ...


Home improvement Q&A
Columbus Ledger-Enquirer, GA - 3 hours ago
(Want Alan J. Heavens' advice on a home-improvement project or purchase? E-mail him at aheavens@phillynews.com or write to him at The Inquirer, Box 8263, ...


AG Van Hollen: Home improvement company and owner charged with ...
Wisbusiness.com, WI - 20 hours ago
The complaint alleges that in November, 2005 defendants entered into a $55250 home improvement contract with a Menasha couple promising, among other things, ...


Economic Downturn Sparks New Home Improvement Trend
MarketWatch - Nov 18, 2008
With the harsh reality of uncertain economic times, and the average consumer shouldering $10000 or more in credit card debt, a new trend in home improvement ...


Canada.com

Endeavour Docks at Space Station on Home-Improvement Mission
Bloomberg - Nov 16, 2008
16 (Bloomberg) -- NASA’s space shuttle Endeavour docked with the International Space Station today just after 5 pm New York time on a home-improvement ...
Video: Space Shuttle Endeavour Blasts Into Night Sky AssociatedPress
Endeavour to launch on 'home improvement' flight Spaceflight Now
Shuttle Endeavour docks with ISS on 'home-improvement' mission RIA Novosti
EastDay.com - Space Fellowship
all 5,713 news articles


TheHomeMag Experiencing Continued Growth in Slow Housing Market
MarketWatch - Nov 18, 2008
Additionally, revised numbers from HIRI (Home Improvement Research Institute) show the long-term outlook for the home improvement industry remains strong ...


Royals need home improvement
Reading Eagle, PA - Nov 17, 2008
By Don Stewart Reading, PA - Since the Reading Royals' inaugural 2001-02 season, the Sovereign Center has been a rough place for opposing teams. ...


$2 Million for Home Improvement in Elmira
WETM-TV, NY - Nov 17, 2008
ELMIRA- About two million dollars is up for grabs in the city of Elmira for you to use in home improvement projects. All you have to do is apply! ...

Home-Improvement - Google News

home | site map
© 2006